The Velonex 510 is an easy-to-operate completely solid-state and fully shielded instrument, providing bursts of sine waves. This unit is completely protected against damage by a momentary and sustatined external short. It is fully shielded to prevent extraneous burst signals from feeding into any external equipment and solid-state design eliminates jitter and erratic performance.
Features:
Output Isolation: Provided on the inner conductors of two type UG-931 high-voltage connectors. Output may be directly applied to any power line voltage up to 500 Vrms
Shielding: Transient burst signal generator is fully-shielded to prevent unwanted radiation or conduction of signal
Monitor Output: A low-level 1000:1 attenuated output referenced to ground is provided for scope monitoring
Trigger Output: A front panel scope trigger output signal is provided
High Voltage: Two push buttons (located on opposite sides of the instrument) must be simultaneously pushed in order to obtain high-voltage output
Input Voltage: 115V +/-10%, 60 Hz
Input Power: 80W
Output Voltage: (Open Circuit; crest of 1st Half Cycle Peak) Variable by front panel control from 1.5kV (<300V with a more rapid envelope decay) to 2.5kV
Test Burst Rep Rate: Manual one-shot, plus continuously variable from <20 bursts per second to >120 bursts per second, plus 50 or 60 Hz synchronized with power line, plus 100 or 120 Hz synchronized with power line. Phase or burst is adjustable through >320 degrees with respect to power line frequency
Test Duration: Continuously adjustable from <2 seconds to >10 seconds
